Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Andover, FL

Extension Spring Replacement in Andover, FL

Side-mounted extension springs replaced in matched pairs, with safety cables installed. Typical cost $150-$350.

From the first phone call to the final safety test, extension spring replacement in Andover, FL follows a simple process: diagnose, quote, repair, test. Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Is it time for extension spring replacement?

  • A stretched, sagging or snapped spring along one of the horizontal tracks
  • The door lifts unevenly or sits crooked
  • A missing or broken safety cable through the spring
  • Pulleys squealing or wobbling

Common causes

  • Metal fatigue from years of stretching
  • Rust and worn pulleys
  • Mismatched springs from an earlier repair

What you can check yourself

  • Make sure each extension spring has a safety cable running through it. That cable keeps a snapped spring from flying across the garage.
  • Look at the pulleys and cables for fraying.
  • Don't try to stretch or re-hook an extension spring under tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle extension spring replacement

  1. Open the door fully and secure it so spring tension is released
  2. Replace both springs as a matched pair, color-coded for door weight
  3. Replace worn pulleys and lift cables if needed
  4. Install or replace the safety containment cables
  5. Balance the door and test it through several cycles

Extension Spring Replacement cost in Andover, FL

$150-$350Typical range, parts & labor
1-1.5 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Local extension spring replacement for Andover, FL

Humidity in Florida puts a thin layer of rust on spring coils, and that friction wears springs out early. Coated or galvanized springs last noticeably longer here.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Technicians serve all of Andover (ZIP codes 33023, 33163 and 33169), plus Norland (1.3 mi), West Park (1.4 mi), Miramar (1.8 mi) and Lake Lucerne (1.8 mi). Call (833) 435-8883 to book a visit in Andover.

Extension Spring Replacement: frequently asked questions

How much does extension spring replacement cost in Andover, FL?

Extension Spring Replacement typically costs $150-$350 including parts and labor, and usually takes 1-1.5 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do extension spring replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is extension spring replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Florida or Andover requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Andover, FL

Hörmann Garage Door Installation

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $1,200-$4,500

Craftsman Garage Door Sensor Repair

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $100-$250

Raynor Remote & Keypad Programming

Remotes, keypads and car buttons matched and programmed to your opener.

Typical $50-$150

Holmes Garage Door Garage Door Track Repair

Bent, loose or misaligned tracks straightened, realigned or replaced.

Typical $150-$400

Rytec High-Speed Door Repair

Rytec specializes in high-speed doors for warehouses, manufacturing and cold storage.

Typical $400-$2,000

Haas Door Garage Door Track Repair

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $150-$400

Wayne Dalton Garage Door Roller Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$350

Loading Dock Door Repair

Dock doors, seals and bumpers repaired to keep shipping moving.

Typical $300-$1,200

Holmes Garage Door Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Cornell Cookson Commercial Garage Door Repair

Cornell Cookson makes rolling steel service doors, security grilles and rolling fire doors.

Typical $250-$1,000

Screw Drive Opener Repair

Screw-drive openers cleaned, lubricated and repaired.

Typical $125-$350

Garage door stuck, noisy or broken?

Talk to a garage door technician in Andover, FL now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote